Link-systems OmniLink - PLC Interface Manual de usuario descargar pdf (Pagina 45)

June 5, 2000 Man ual Rev 1 .0 5.18

Value:

Standard Numeric

Meaning:

0 = All Conditions OK

1 = Communication Failure

2 = Bypassed

3 = Error Condition Exists - See Channel Status

4 = Option is Not Installed

Section 5.7.56 Parameter 056 - Auto-Setup Module Enabled Flag

Value:

Standard Numeric

Meaning:

0 = Auto-Setup NOT enabled

1 = Auto-Setup enabled

Section 5.7.57 Parameter 057 - Auto-Setup Slide Adjust Switch Flag

Value:

Standard Numeric

Meaning:

The slide adjust switch position as reported by the auto-setup module.

0 = Slide adjust switch OFF

1 = Slide adjust switch ON

Section 5.7.58 Parameter 058 - Auto-Setup Module Status Code

Value:

Standard Numeric

Meaning:

0 = All Conditions OK

Non-Zero = Error Condition Exists

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51 52 53

OmniLink 5000 1
Table of Contents 3

Comentarios a estos manuales

Sin comentarios