Link-systems OmniLink - PLC Interface Manual de usuario descargar pdf (Pagina 53)

June 5, 2000 Man ual Rev 1 .0 5.26

The format to select a parameter status message is:

From PLC:

[LF]VS[PNUM]=[MNUM][CR]

where:

[PNUM] is the two digit parameter number (with leading zero if necessary) .

[MNUM] is the message number that is to be set for the line.

Reply From Link:

[LF]VSA[PNUM]=[MNUM][CR]

where:

[PNUM] is the two digit parameter number (with leading zero if necessary) .

[MNUM] is the message number that was set for the line.

It is strongly recommended that the PLC check the return reply to verify the message arrived correctly at

the OmniLink.

1 2 ... 48 49 50 51 52 53

Sin comentarios

Link-systems OmniLink - PLC Interface Manual de usuario Pagina 53