Link-systems LinkNet II Manual de usuario Pagina 66
- Pagina / 99
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
5.2.3 Average Tonnage Graph Detail
The average
tonnage detail screen
(“Average Tons
Graph” tab - see
Figure 5.4) graphically
shows the average
tonnage for a machine
for the last 8 hours,
last 24 hours, or the
current run. The
default is the current
run, but clicking the
“Last 8 Hours” or
“Last 24 Hours”
buttons near the
bottom of the dialog
box will change the
time scale.
The average
tonnage, highest good
tonnage, and lowest
good tonnage are
collected in 10 minute
intervals (unless a job is changed, in which case the interval is terminated to keep the tonnages
associated with the correct job).
Figure 5.4: Machine Detail “Average Tonnage Graph” Dialog Box
The highest good tonnage is the highest tonnage that did not exceed the high setpoint and the lowest
good tonnage is the lowest tonnage that did not go below the low setpoint. The average tonnage is the
average of all in-limit hits.
This screen shows the average tonnages as an area graph, the highest good tonnage as a line graph,
and the lowest good tonnage as a line graph. The average tonnage for each different job run on the
machine appears in a different color.
The graph is arranged by time of day and can be zoomed if greater detail is desired from a section of
the total graph. To zoom in on the graph, move the mouse pointer to one corner of the area to zoom in
on, hold down the left mouse button, and without letting up on the button, move the mouse to the other
corner of the area to zoom in on. When the mouse is being dragged to the second corner, a rectangle
will show the zoom area. Note that after a zoom, the graph can be zoomed again to go even further in.
To restore the graph to the full view, click on the “Undo Zoom” button.
To export the graph to a file or clipboard for use by other windows programs, click in the “Export”
button. A window will appear with choices about where to send the graph.
To print the graph, click on the “Print” button. The graph will be sent to the default windows
printer.
Manual Version 1.1 10/28/2001
5.4
- LinkNet 2 inkNet 2 1
- Table of Contents 3
- Table of Figures 6
- Section 1 Introduction 9
- Section 2 Installation 11
- View) Network Connections 14
- Network Port 15
- Section 3 Terminology 19
- Section 4 Configuration 23
- Configuration Dialog 27
- Figure 4.19: Machine Listing 38
- Figure 4.27: Tool Listing 46
- Figure 4.30: Part Listing 49
- Figure 4.33: Job Listing 52
- Section 5 Using LinkNet 63
- Section 6 Reports 69
- Configuration Screen 80
- Terminal) 86
Relacionado con productos y manuales para Instrumentos de medición Link-systems LinkNet II
(119 paginas)
Instrumentos de medición Link-systems OmniLink II Press Automation Control Manual de usuario
(154 paginas)
(154 paginas)
Instrumentos de medición Link-systems Omni II Automatic Setups Module Manual de usuario
(77 paginas)
(77 paginas)
Pasco ME-9496 Time Pulse Accessory podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Ekwipunek Pasco ME-9496 Time Pulse Accessory.
Dostarczamy 1 pdf podręczników Pasco ME-9496 Time Pulse Accessory do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Comentarios a estos manuales